Monit GPS Antenna Bulkhead Mount

Monit GPS Antenna Bulkhead MountThe Monit bulkhead mount antenna is a high sensitivity GPS GNSS antenna with an integrated screw mounting stud and nut. This can be used to securely fasten the antenna through a vehicles roof or to a suitable mounting bracket. The mounting stud and antenna housing are sealed to prevent water ingress if a hole is made in the roof to accommodate the low profile antenna. Cable Length 5M

Can be used with conventional steel discs

With the flexibility to use its integrated GPS+ receiver or speed sensors

Venti4 works with all Stilo WRC wired or wireless intercoms through its integrated electronics and new Nexus connection which has been developed to further protect damage being inflicted to the plugs

52L x 33W x 37H

We can also supply the linear sensor as used on some early Hewland gearboxes

sealed AGM (MF) or GEL and 12

These Stand 21 FIA 8858-2010 FHR (HANS) clips are manufactured to fit Snell SA2010 and SA2015 helmets that are also approved for use with the HANS device to the latest FIA 8859 and earlier FIA 8858-2010 standard

Motamec Racing Info:

30% less weight than the standard fibreglass seat

or calculated from Speed/RPMFully configurable alarm functions for all channelsFully configurable CAN transmit function for use as a CAN relay etc

Mating connector included

4 x Sill Tubes & 8 x strengthening plates for Motamec WRC Sill Stands withMild steel to weld in to car sillsTo suit 20mm / 25mm Pins1 Car SetEnd Caps includedSold as a set