1/16 Scale .07 SH Engine Pull Starter fits RC Nitro Car

1/16 Scale .07 SH Engine Pull Starter fits RC Nitro Car. 07 SH Engine Pull Starter. May fit other cars below is the measurements.. 8mm Hex Fitting 25mm Length 25mm High Note: Center of pull starter is held together with tape when installing remove the tape and ensure the center does not pop out. If it does the pull starter insides will spring out. Hold it together whilst installing onto the engine. We also stock electric starters to fit this model. Other starters in stock simple ask and give the height

starter rod

Distance between center of fixed holes across is 27mm (same for all sides)

Includes 1 servo horn and 1 fixing screw for the servo horn only

- Across the center of fixing holes

To check if this will fit your model remove the pull starter and check the measurements

Listing for backplate only

Will also fit BSD model copies

Newly designed with even stronger grip handle

Redcat and Himoto

Most 1/10s and 1/8s models

To check these wheels will fit your model please check measurements below: 105mm External Diameter - 71mm Internal Diameter - 48mm Width - 12mm hex hub - 20mm edge of wheel to edge of hex hub

12mm Hex Fitting 32mm Length (end to end) 32mm High (end to end) 27mm across center fixing holes 19mm Deptch Other starters in stock simple ask and give the height length and the hex (nut size) of your current pull starter