End mill holder Weldon with cooling channels BT 40 - 32 - 100

End mill holder Weldon with cooling channels BT 40 - 32 - 100Application: For mounting straight shank tools with lateral flat according to DIN 1835 form B (Weldon). Delivery: With clamping screw and O ring All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

Adapters HSK / PSK with axial clamping

for mounting on a wall

Stainless steel

00005" / 0

Only nominal size d can be clamped with sealing plug for internal cooling (applicable up to 21 bar) In order to achieve an optimum sealing the tool must be clamped on the complete length of the ground drill of the collet

Measuring surfaces are carbide

6 µm radial run-out with a 5 µm clamping nut

Individual serial numbers on each block

5 x 58 x 18

For internal machining with boring bars

For mounting straight-shank tools

Calibration certificat