Shaft Vibration Extension Cable | EZ1900-040 Emerson

Shaft Vibration Extension Cable | EZ1900-040 EmersonProduct Overview The Emerson EZ1900 040 functions as a high performance 4 meter extension link for the AMS EZ 1000 series eddy current sensors. This cable bridges the gap between the displacement sensor head and the monitoring system, enabling precise tracking of shaft vibration, eccentricity, and axial displacement. Specifically designed for critical rotating machinery like turbines and gearboxes, the EZ1900 040 preserves signal integrity and

and converts the binary inputs into structured digital data arrays for the central Honeywell C300 controller

Update Rate: Synchronous with the M1 system bus cycle

When configured in a DLR topology

5 MB (Non-volatile Flash / Battery-backed RAM)

Configuration: Verify that all hardware-level trip request jumpers are set according to the specific site logic documentation prior to energizing the module

the 8202-HO-IS enables advanced digital diagnostics and device status reporting directly through the analog loop

This allows the EZ1900-040 to maintain signal stability in the high-heat environments typical of steam turbines and large industrial compressors

A: The system supports simultaneous remote data transmission via native Modbus RTU

The internal firmware monitors both Trunk A and Trunk B paths simultaneously

EN61000-6-4 (Emissions) Industrial Drives

This critical security component provides a hardened layer of network isolation

It replaces legacy analog systems with advanced digital logic