Replica Westinghouse Generator (Use Drop Down Box Below)

Replica Westinghouse Generator (Use Drop Down Box Below)This faux unit looks virtually identical to the Westinghouse generator that was used on the late Springfield cars, but contains a modern 40 amp alternator. It is available in 6 or 12 volt, negative ground only. Although not necessary for operation, you must supply the brush cover band and bearing covers from your old unit for cosmetics (brush cover band shown installed in upper three pictures). It is a direct bolt on replacement, and has an internal

SGA research into oil pump drive coupling failures has identified one or more common oil pump coupling failures being caused by the relatively large difference between the sizes of the square driving and driven shafts

The diameter has been increased to give more ‘wrap’ for better traction at relatively low belt tensions

05 ea                                        INCLUDES: 8 TEST LUGS

it can be corrected on the device so the mileage matched the tour book

This pulley is made specially by the SGA for installation of Nippon Denzo alternators above

(26 Pieces Per Set) MP-104-117 US $16

and are duplicates of the original right down to the finish and the hole pattern that isn’t quite quartered

The points plate is held firmly and wont rotate as the tool has the same tapered fit and keyway as the magneto does

they will need to be remagnetized for the strongest spark

The unit contains a properly designed power supply and coils with fully adjustable ground pole pieces

MP-JK38458

Special bracket with drilled and tapped holes for spark plugs so the magneto can be loaded properly and so you can see the spark for each cylinder